

- #Vida dice firmware light blinks how to
- #Vida dice firmware light blinks update
- #Vida dice firmware light blinks manual
- #Vida dice firmware light blinks android
All i would get is a flashing blue/red light no matter what I tried. I had resolved to the fact it must be a broken firewire interface card or worse, a lemon FSP. I tried swapping cables and even more recently moved my texas instruments-chipset 1394a 400 card to a different PCI slot thinking a bad seat of the card may have been the problem but to no avail. I purchased a FSProject a year and a 1/2 ago and it was working fine up until about 6 months ago(maybe longer) when it all of a sudden would not sync.
#Vida dice firmware light blinks manual
I hope you used a clean formatted SD to load the firmware on while trying the manual method and followed the directions.I know others have had this problem and I wanted to post this comment hoping it will help the community.
#Vida dice firmware light blinks update
Make sure you tell them that you already tried the manual firmware update method.

I had good luck calling the 1-844 number at about 9 AM Pacific time. I would submit a ticket, get the the ticket number from Wyze then call them at the number I posted or 20 M-F 4 AM to 8PM Pacific time.


I switched all the cams to scheduled event record. I cancelled the CP accounts and I can again save the events if I desire. After about a week or so I figured out the issue was caused by my cam plus account. I finally called them on the phone and they sent me a new base to try because none of the solutions we tried fixed the issue. I worked with support on the issue via 3 tickets and email for about a month. I had Cam Plus on all 4 WCO but after the firmware update in February I couldn’t download any of the event videos to save on my phone. No I did not buy another base, I got it from Wyze. If I reboot everything, the base station and one or two cameras will come online for a few minutes then disconnect (even if I move the cameras right next to the base station). When the cameras were moved into place - no more than 30’ from the base station - the system worked for about an hour, then the base station dropped offline. I then loaded the June 14th firmware and the cameras connected and stayed online for several hours - as long as I left all the cameras on the same desk within a few feet of the base station. I updated back to the April 19 firmware and the behavior was the same. The base station would only communicate with the cameras for about 5-10 minutes then the base station would start blinking yellow and blue and the cameras would go offline. The other two repeatedly failed when trying to add the device. I deleted all devices from the app and tried re-attaching. No luck reverting back to the March 9 firmware version (.14) for the base station and cameras. Wyze Cam Outdoor firmware files can be found on the Release Notes page.ĭownload the specific version of firmware from the Release Notes.
#Vida dice firmware light blinks how to
? Wyze How to flash your Wyze Cam Outdoor firmware manually
#Vida dice firmware light blinks android
Are you using an Android device or iOS (Apple) device. After you get the file just put the SD in the base and follow directions. You most know at least on person or maybe at work where you can use a computer to download the firmware file. Can’t you find a Cheap Micro SD card with adapter $7-10, find a person or library with a computer with SD card slot down load the file to the SD the follow the post above. If you tapped on that you could revert back. The way is was before was open the app, >tap the base > tap the gear icon top right which would take you to settings > tap device info > tap firmware and it would show which version you had and would say “having problem” in green letters. Well there was a way in the app but I just looked at mine and the choice to change it back is not there.
